# $Id: trt.conf 1167 2006-12-12 12:37:20Z angelov $
#
# PCI
CARD = 0
#
# identify tester board, must be at the beginning in order to read the proper adc_calibration
#TESTER_BOARD_ID = wafer_tester_02
TESTER_BOARD_ID = AUTO
#
OUTPUT_LEVEL = result
OUTPUT_LEVEL = fatal
OUTPUT_LEVEL = warning
OUTPUT_LEVEL = info
#
### force usage of link 1 to avoid troubles (at least on wafer 46)
#
FORCE_LINK_1 = 0
#
# ADC reference voltage for supply voltage measurement
# in V is the first line in adc_calibration
#
# current limit of 0x700 is reached when power is switch on even with good chip
# hexadecimal numbers are considered raw values,
# decimal numbers are in mA
#
CURRENT_LIMIT_ANALOG = 300
CURRENT_LIMIT_DIGITAL = 300
#
CURRENT_1V8_DIGITAL_IDLE_HIGH = 70
CURRENT_3V3_DIGITAL_IDLE = 50
CURRENT_1V8_ANALOG_IDLE = 30
#
CURRENT_1V8_DIGITAL_FILTER = 195
CURRENT_3V3_DIGITAL_FILTER = 50
CURRENT_1V8_ANALOG_FILTER = 130
#
# maximal voltage differences for supply voltages in V
#
VOLTAGE_1V8_DIGITAL_MAX = 0.02 
VOLTAGE_1V8_ANALOG_MAX = 0.02
VOLTAGE_3V3_DIGITAL_MAX = 0.02

# frequency in kHz
DDS_FREQ = 200
# DDS p-p in V
DDS_AMP = 1.1
DDS_VCM = 0x718
#
# desired supply voltages in V
#
SUPPLY_VOLTAGE_1V8_ANALOG = 1.8
SUPPLY_VOLTAGE_1V8_DIGITAL = 1.8
SUPPLY_VOLTAGE_3V3_DIGITAL = 3.3
#
SUPPLY_VOLTAGE_1V8_DIGITAL_ADDITIONAL = 1.7

### DMEM delay settings
DMDELA = 1
DMDELS = 12
QDA_MIN_CONST = 4

LESS_ADCS_WAFER = 1